Dell 9.7(0.0) manual Debug ipv6 dhcp, Default-router

VersionDescription

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the C-Series and S-Series.

debug ipv6 dhcp

To enable debug logs for DHCPv6 relay agent transactions.

Syntax debug ipv6 dhcp

Defaults

Command Modes

Command History

To disable the debug logs for dhcpv6 relay agent transactions, use the debug ipv6 dhcp command.

none

EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command-Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.

default-router

Assign a default gateway to clients based on the address pool.

S6000

Syntax	default-routeraddress [address2...address8]
Parameters	address	Enter a list of routers that may be the default gateway for
		clients on the subnet. You may specify up to eight routers.
		List them in order of preference.
Defaults	none
Command	DHCP <POOL>
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

548 Dynamic Host Configuration Protocol (DHCP)