Parameters

Defaults

Command Modes

Command History

access-list-

Enter the name of an established IP Standard ACL.

name

 

Not configured.

 

LINE

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.2.1.1

Introduced on the E-Series.

Related Commands

line — applies an authentication method list to the designated terminal lines.

ip access-list standard — names (or selects) a standard access list to filter based on the IP address.

ip access-list extended — names (or selects) an extended access list based on the IP addresses or protocols.

enable password

Change the password for the enable command.

Syntaxenable password [level level] [encryption-type] password

To delete a password, use the no enable password [encryption-type]password [level level] command.

Parameters

level level

encryption- type

(OPTIONAL) Enter the keyword level then a number as the level of access. The range is from 1 to 15.

(OPTIONAL) Enter the number 7 or 0 as the encryption type.

Security

1377

Page 1377
Image 1377
Dell 9.7(0.0) manual Enable password, Name Not configured, Syntaxenable password level level encryption-type password