Dell 9.7(0.0) manual Protocol-tunnel rate-limit rate

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.4.1.0Introduced

Usage	Dell Networking OS must have the default CAM profile with the default microcode
Information	before you enable L2PT.

protocol-tunnel rate-limit

Enable traffic rate limiting per box.

Syntax protocol-tunnel rate-limit rate

Parameters

Defaults

Command Modes

Command History

To reset the rate limit to the default, use the no protocol-tunnelrate-limitrate command.

rate	Enter the rate in frames per second. The range is from 75 to
	3000. The default is 75.

75 frames per second.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the C-Series, E-Series TeraScale, and E- Series ExaScale. Maximum rate limit on E-Series reduced from 4000 to 3000.

1460 Service Provider Bridging