Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.5(0.0)

Introduced on the Z9500.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.8.1.0Introduced on the C-Series on port-channels and the S- Series.

Usage

The router with the largest value assigned to an interface becomes the designated

Information

router. If two interfaces contain the same designated router priority value, the

 

interface with the largest interface IP address becomes the designated router.

ip pim join-filter

Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group.

S6000

Syntaxip pim [vrf vrf-name] join-filter ext-access-list

Parameters

Defaults

Command Modes

Command History

To remove the access list, use the no ip pim [vrf vrf-name]join-filterext-access-listcommand.

vrf vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of

 

the VRF to permit or deny PIM join or prune messages on an

 

interface associated with that VRF.

ext-access-list

Enter the name of an extended access list.

none

 

INTERFACE

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Removed the in and out parameters. Introduced on the

 

S6000-ON.

PIM-Sparse Mode (PIM-SM)

1193

Page 1193
Image 1193
Dell 9.7(0.0) manual Ip pim join-filter, Syntaxip pim vrf vrf-name join-filter ext-access-list, Ext-access-list