The weight for weighted ECMP route calculations is displayed for each path in the
route in show ip route command. The ECMP weight is displayed only if
weighted ECMP is enabled using the ip ecmp weighted command is enabled.
If weighted ECMP is disabled, the show ip route command does not show the
weighted ECMP route information.
Example Dell#show ip route all
Codes:C- connected, S - static, R - RIP
B- BGP, IN - internal BGP, EX - external BGP, LO -
Locally Originated
O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external
type 1
N2- OSPF NSSA external type 2, E1 - OSPF external type 1
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate
default
>- non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, Te 2/8 120/1 00:07:12
via 101.10.10.10, Te 2/9
100.10.10.0/24 Direct, Te 2/8 0/0 00:08:54
> R 100.10.10.0/24 Direct, Te 2/8 120/0 00:08:54
C 101.10.10.0/24 Direct, Te 2/9 0/0 00:09:15
> R 101.10.10.0/24 Direct, Te 2/9 120/0 00:09:15
Dell#
Example
(Summary) Dell#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
R1_E600i>show ip route static ?
| Pipe through a command
<cr>
R1_E600i>show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Te 1/2 1/0 3d2h
Dell>
Example (vrf) Dell#show ip route vrf test1
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO -
Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external
type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * -
candidate default,
IPv4 Routing 807