Dell 9.7(0.0) Show port-channel-flow, Example Related Commands Field Description, Untitled, Lag

Example

Related Commands

Field	Description
LAG	Lists the port channel number.
Mode	Lists the mode:
	• L3 — for Layer 3
	• L2 — for Layer 2
Status	Displays the status of the port channel.
	• down — if the port channel is disabled (shutdown)
	• up — if the port channel is enabled (no shutdown)
Uptime	Displays the age of the port channel in
	hours:minutes:seconds.
Ports	Lists the interfaces assigned to this port channel.
(untitled)	Displays the status of the physical interfaces (up or down).
	• In Layer 2 port channels, an * (asterisk) indicates which
	interface is the primary port of the port channel. The
	primary port sends out interface PDU.
	• In Layer 3 port channels, the primary port is not
	indicated.

Dell#show interfaces port-channel 1 brief

LAG	Mode	Status	Uptime	Ports
1	L2	up	00:00:08	Te 3/1 (Up) *
				Te	3/2 (Down)
Dell#				Te	3/3 (Up)

show lacp — displays the LACP matrix.

show port-channel-flow

Display an egress port in a given port-channel flow.

S6000

Syntax

Parameters

show port-channel-flow outgoing-port-channel number incoming- interface interface {source-ip address destination-ip address}

{source-port number destination-port number} {source-mac address destination-mac address {vlan vlanid ether-type}}

outgoing-port-	Enter the keywords outgoing-port-channelthen the
channel	number of the port channel to display flow information.
number	• For a Port Channel interface, enter the keywords port-
	channel then a number. The range is from 1 to 128.

738 Interfaces