SPANNING TREE Mode

To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information, refer to Spanning Tree Protocol (STP).

To enter SPANNING TREE mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the protocol spanning-treestp-idcommand. The prompt changes to include (conf-stp).

You can return to CONFIGURATION mode by using the exit command.

TRACE-LIST Mode

To configure a Trace list, use TRACE-LIST mode.

To enter TRACE-LIST mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the ip trace-listcommand. Include the name of the Trace list. The prompt changes to include (conf-trace-acl).

You can exit this mode by using the exit command.

VLT DOMAIN Mode

To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, refer to Virtual Link Trunking (VLT).

To enter VLT DOMAIN mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the vlt domaincommand then the VLT domain number. The prompt changes to include (conf-vlt-domain).

You can return to CONFIGURATION mode by entering the exit command.

VRRP Mode

To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information, refer to Virtual Router Redundancy Protocol (VRRP).

To enter VRRP mode:

1.To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.

2.Enter the vrrp-groupcommand then enter the VRRP group ID. The prompt changes to include (conf-if-interface-type-slot/port-vrid-vrrp-group-id).

CLI Basics

57

Page 57
Image 57
Dell 9.7(0.0) manual Spanning Tree Mode, TRACE-LIST Mode, VLT Domain Mode, Vrrp Mode