Dell 9.7(0.0) Hardware watchdog, Show hardware layer2, Parameters Eg-acl in-acl, Stack-unit id

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.7(0.0)	Introduced this command.

hardware watchdog

To trigger a reboot and restart the system, set the watchdog timer.

Syntax	hardware watchdog stack-unit {<0-5> all}
Defaults	Enabled.
Command	CONFIGURATION
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.0Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

Usage	This command enables a hardware watchdog mechanism that automatically
Information	reboots an Dell Networking OS switch/ router with a single unresponsive unit. This
	behavior is a last-resort mechanism intended to prevent a manual power cycle.

show hardware layer2

Display Layer 2 ACL or eg data for the selected stack member and stack member port-pipe.

Syntax	show hardware layer2 {eg-acl in-acl} stack-unit id port-set
	0–0
Parameters	eg-acl in-acl	Enter either the keyword eg-aclor the keyword in-aclto
		select between ingress or egress ACL data.
	stack-unit id	Enter the keyword stack-unitto select a stack ID. The
		range is from 0 to 5.
	port-set 0–0	Enter the keywords port-setwith a port-pipe number. .
Defaults	none

Debugging and Diagnostics 529