Parameters

Defaults

Command Modes

Command History

To return to the default setting, use the no ip telnet source-interface [interface] command.

interface

Enter the following keywords and slot/port or number

 

information:

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For Loopback interfaces, enter the keyword loopback

 

then a number from zero (0) to 16383.

 

• For a port channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

 

• For VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

 

• For a tunnel interface, enter the keyword tunnel.

The IP address on the system that is closest to the Telnet address is used in the outgoing packets.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.2.1.0Increased number of VLANs on ExaScale to 4094 (was 2094).

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

E-Series

Original command

114

Control and Monitoring

Page 114
Image 114
Dell 9.7(0.0) manual For Loopback interfaces, enter the keyword loopback