tunnel [ipv4- over-ipv4 ipv4-over-gre- ipv4 mac-in- mac]}

•ethertype — Use Ethertype field in hash calculation.

•source-dest-mac — Use SMAC and DMAC fields in hash calculation.

To use tunnel key fields in hash computation, enter the keyword tunnel then one of the parameters:

•ipv4-over-ipv4 — Use ipv4-over-ipv4 field in hash calculation.

•ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 field in hash calculation.

•mac-in-mac — Use mac-in-mac field in hash calculation.

Defaults

Command Modes

Command History

IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest- port).

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.0.0.0Added support for IPv6.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

management route

Configure a static route that points to the Management interface or a forwarding router.

S6000

Syntaxmanagement route {{ip-address mask {ipv6-address prefix- length}} {forwarding-router-address managementethernet

fortyGigE vlan tengigabitethernet}

To remove a static route, use the no management route{{ip-address mask {ipv6-addressprefix-length}}{forwarding-router-address

784

IPv4 Routing

Page 784
Image 784
Dell 9.7(0.0) Management route, Tunnel ipv4- over-ipv4 ipv4-over-gre- ipv4 mac-in- mac, FortyGigE vlan tengigabitethernet