Dell 9.7(0.0) manual Peer-link port-channel, Peer-down, Vlan vlan id

Parameters

Command Modes

Command History

value	Enter the timeout value in seconds. The range is from 1 to
	1200. The default is 150.

VLT DOMAIN (conf-vlt-domain)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.5(0.0)	Introduced on the Z9500.
9.2(0.0)	Introduced on the M I/O Aggregator. This command is
	supported in Programmable-Mux (PMUX) mode only.
9.2(0.2)	Introduced on the Z9000, S4810, and S4820T.

9.0.2.0Introduced on the S6000.

peer-link port-channel

Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.

Syntax

Parameters

Defaults

Command Modes

Command History

peer-link port-channel port-channel-number{peer-down-vlan vlan

id}

port-channel-	Enter the port-channel number that acts as the interconnect
number	trunk. The range is from 1 to 128.
peer-down-	Enter the keyword peer-down-vlanthen a VLAN ID to
vlan vlan id	configure the VLAN that the VLT peer link uses when the VLT
	peer is down.
Not configured.
VLT DOMAIN

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Virtual Link Trunking (VLT) 1631