Based on whether VRF feature is identified as supported in the Feature Configuration file, configuration
command feature vrf becomes available for usage. This command will be stored in running-configuration
and will precede all other VRF-related configurations.
NOTE: The MXL and Z9000 platforms currently do not support VRF. These platforms support only
the management and default VRFs, which are available by default. As a result, the feature vrf
command is not available for these platforms.
To display the state of Dell Networking OS features:
Dell#show feature
Example of show feature output
For a particular target where VRF is enabled, the show output is similar to the following:
Feature State
------------------------------
VRF enabled
feature vrf
Enable the VRF application on a switch. After you enable the VRF feature, you cannot deactivate it.
S6000
Syntax feature vrf
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History Version 9.5(0.0) Introduced on the Z9500.
Version 9.4(0.0) Introduced on the S4810, S4820T, S5000, and S6000.
Usage
Information
You can activate VRF application on a device by using the feature vrf command
in CONFIGURATION mode. The no feature vrf command is not supported on
any platform.
show feature
Verify the status of software applications, such as VRF, that are activated and running on a device.
S6000
Syntax show feature
Command
Modes
EXEC
EXEC Privilege
Command
History Version 9.4(0.0) Introduced on the S4810, S4820T, and S6000.
48 CLI Basics