Dell 9.7(0.0) manual Ip telnet server vrf, Ip telnet source-interface, Vrf, Management

ip telnet server vrf

Configures the TELNET server on either a specific VRF or a management VRF.

S6000

Syntax ip telnet server vrf {management vrf-name}

Parameters

Defaults

Command Modes

Command History

Usage Information

Example

To undo the TELNET server configuration, use the no ip telnet server [vrf vrf-name]command.

vrf	Enter the keyword vrf followed by the keyword
management	management to specify a management VRF that is used by
	the TELNET server.
vrf vrf-name	Enter the keyword vrf and then the name of the VRF to
	specify the VRF that is used by the TELNET server.
Disabled
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.5(0.0)	Introduced on the Z9500.
9.4.(0.0)	Introduced on the S-Series and Z9000.

You can enable the TELNET server on either a management VRF or a user-defined VRF but not both. If you do not specify a VRF name, then the TELNET server is enabled on the default VRF.

Dell(conf)#ip telnet server vrf vrf1

Dell(conf)#no ip telnet server vrf

Dell(conf)#ip telnet server vrf management

Dell(conf)#no ip telnet server vrf

ip telnet source-interface

Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.

Syntax ip telnet source-interface interface

Control and Monitoring 113