Defaults

Command Modes

Command History

Usage Information

Example

description

Enter a description of up to 80 characters.

Not configured.

•CONFIGURATION-STANDARD-ACCESS-LIST

•CONFIGURATION-EXTENDED-ACCESS-LIST

•CONFIGURATION-MAC ACCESS LIST-STANDARD

•CONFIGURATION-MAC ACCESS LIST-EXTENDED

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.4.1.0Introduced on the E-Series.

The remark command is available in each ACL mode. You can configure up to 4294967290 remarks in a given ACL.

The following example shows the use of the remark command twice within CONFIGURATION-STANDARD-ACCESS-LIST mode. The same sequence number was used for the remark and for an associated ACL rule. The remark precedes the rule in the running-config because it is assumed that the remark is for the rule with the same sequence number, or the group of rules that follow the remark.

Dell(config-std-nacl)#remark 10 Deny rest of the traffic Dell(config-std-nacl)#remark 5 Permit traffic from XYZ Inc. Dell(config-std-nacl)#show config

!

ip access-list standard test

remark 5 Permit traffic from XYZ Inc. seq 5 permit 1.1.1.0/24

remark 10 Deny rest of the traffic seq 10 Deny any Dell(config-std-nacl)#

Access Control Lists (ACL)

183

Page 183
Image 183
Dell 9.7(0.0) manual Description Enter a description of up to 80 characters, VersionDescription 70.0