Command Modes

Command History

Usage Information

 

NOTE: You can use this attribute on a specific VRF to

 

remove history routes corresponding to that VRF. You

 

can also use this attribute to return the suppressed

 

routes corresponding to a specific VRF to an active state.

ipv4 multicast

(OPTIONAL) Enter the keyword ipv4 followed by the

 

keyword multicast to clear the ipv4 multicast routes.

ipv4 unicast

(OPTIONAL) Enter the keyword ipv4 followed by the

 

keyword unicast to clear the ipv4 unicast routes.

ipv6 unicast

(OPTIONAL) Enter the keyword ipv6 followed by the

 

keyword unicast to clear the ipv6 unicast routes.

ipv4-address

(OPTIONAL) Enter an IPv4 address in dotted decimal format

mask

and the prefix mask in slash format (/x) to clear dampening

 

information only that BGP neighbor.

ipv6–address

(OPTIONAL) Enter the IPv6 address and the network mask to

mask

clear information on IPv6 route dampening.

EXEC Privilege

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Added the ipv4 multicast and ipv6 unicast parameters.

9.4.(0.0)

Added support for VRF.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

After you enter this command, the software deletes the history routes and returns the suppressed routes to the Active state.

The clear ip bgp dampening command does not clear the history paths.

364

Border Gateway Protocol

Page 364
Image 364
Dell 9.7(0.0) manual Ipv4 unicast, Ipv4-address