Usage Information

Example

Related Commands

VersionDescription

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.4.1.0Introduced

You cannot delete a physical interface.

By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or switchport. To place an interface in Layer 2 mode, ensure that the interface’s configuration does not contain an IP address and enter the switchport command.

You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default configuration. To delete a tunnel interface, use the no interface tunnel tunnel-idcommand.

The tunnel interface operates as an ECMP (equal cost multi path) only when the next hop to the tunnel destination is over a physical interface. If you select any other interface as the next hop to the tunnel destination, the tunnel interface does not operate as an ECMP.

Dell(conf)#int tengigabitethernet 1/10

Dell(conf-if-te-1/10)#exit

Dell(conf)#

interface loopback — configures a Loopback interface.

interface null — configures a Null interface. interface port-channel — configures a port channel. interface vlan — configures a VLAN.

show interfaces — displays the interface configuration.

Interfaces

675

Page 675
Image 675
Dell 9.7(0.0) manual 675