Dell 9.7(0.0) manual Match origin, Related Commands VersionDescription 70.0, Parameters Egp, Igp

Related Commands

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

match interface — redistributes routes that match the next-hop interface.

match ip address — redistributes routes that match an IP address.

match ip next-hop — redistributes routes that match the next-hop IP address.

match ip route-source — redistributes routes that match routes advertised by other routers.

match route-type — redistributes routes that match a route type.

match tag — redistributes routes that match a specific tag.

match origin

To match routes based on the value found in the BGP path ORIGIN attribute, configure a filter.

Syntax	match origin {egp igp incomplete}
	To disable matching filter, use the no match origin {igp egp
	incomplete} command.
Parameters	egp	Enter the keyword egp to match routes originating outside
		the AS.
	igp	Enter the keyword igp to match routes originating within
		the same AS.
	incomplete	Enter the keyword incomplete to match routes with
		incomplete routing information.
Defaults	Not configured.
Command	ROUTE-MAP
Modes

Access Control Lists (ACL) 253