Example

Related Commands

VersionDescription

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series.

Dell#clear dampening tegigabitethernet 1/10

Clear dampening counters on TeGi 1/10 [confirm] y Dell#

show interfaces dampening — displays interface dampening information. dampening — configures dampening on an interface.

dampening

Configure dampening on an interface.

S6000

Syntax

dampening [[[[half-life][reuse-threshold]] [suppress-

 

threshold]] [max-suppress-time]]

Parameters

half-life

Enter the number of seconds after which the penalty is

 

 

 

decreased. The penalty decreases half after the half-life

 

 

period expires. The range is from 1 to 30 seconds. The

 

 

default is 5 seconds.

 

reuse-

Enter a number as the reuse threshold, the penalty value

 

threshold

below which the interface state is changed to “up”. The

 

 

range is from 1 to 20000. The default is 750.

 

suppress-

Enter a number as the suppress threshold, the penalty value

 

threshold

above which the interface state is changed to “error

 

 

disabled”. The range is from 1 to 20000. The default is 2500.

 

max-suppress-

Enter the maximum number for which a route can be

 

time

suppressed. The default is four times the half-life value. The

 

 

range is from 1 to 86400. The default is 20 seconds.

Defaults

Disabled.

 

Command

INTERFACE (conf-if-)

 

Modes

 

 

Interfaces

667

Page 667
Image 667
Dell 9.7(0.0) manual Dampening, Suppress, Max-suppress, Time