Dell 9.7(0.0) manual Mac, Name StartingSeqNu, Step-to, Increment

Parameters

Defaults

Command Modes

Command History

Usage Information

ipv4 ipv6	Enter the keyword ipv4or mac to identify the access list type
mac	to resequence.
access-list-	Enter the name of a configured IP access list.
name
StartingSeqNu	Enter the starting sequence number to resequence. The
m	range is from 0 to 4294967290.
Step-to-	Enter the step to increment the sequence number. The
Increment	range is from 1 to 4294967290.
none

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the E-Series ExaScale (IPv6).

8.1.1.0Introduced on the E-Series ExaScale (IPv4).

7.8.1.0Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series.

When you have exhausted all the sequence numbers, this feature permits re- assigning a new sequence number to entries of an existing access-list.

seq

Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.

Syntaxseq sequence-number{deny permit} {source [mask] any host ip-address}} [count [bytes]] [dscp value] [order] [fragments]

Access Control Lists (ACL) 195