VersionDescription

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.5.1.0Introduced.

Usage

By default, Dell Networking OS implements an optimized flush mechanism for

Information

PVST+. This implementation helps in flushing the MAC addresses only when

 

necessary (and less often) allowing for faster convergence during topology

 

changes. However, if a standards-based flush mechanism is needed, you can turn

 

this knob command on to enable flushing MAC addresses after receiving every

 

topology change notification.

vlan bridge-priority

Set the PVST+ bridge-priority for a VLAN or a set of VLANs.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

vlan vlan-rangebridge-priority value

To return to the default value, use the no vlan bridge-prioritycommand.

vlan vlan-rangeEnter the keyword vlan then the VLAN numbers. The range is from 1 to 4094.

bridge-priorityEnter the keywords bridge-prioritythen the bridge

valuepriority value in increments of 4096. The range is from 0 to 61440. The default is 32768.

32768

CONFIGURATION (conf-pvst)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

1240

Per-VLAN Spanning Tree Plus (PVST+)

Page 1240
Image 1240
Dell 9.7(0.0) manual Vlan bridge-priority, Vlan vlan-rangebridge-priority value