Dell 9.7(0.0) manual Storm-control unknown-unicast Interface, Wred-profile name

VersionDescription

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

7.4.1.0E-Series Only: Added the percentage decimal value option.

6.5.1.0Introduced on the E-Series.

Usage	Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
Information

storm-control unknown-unicast (Interface)

Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).

Syntaxstorm-control unknown-unicast [percentage decimal_value in] [wred-profile name]] [packets_per_second in]

To disable unknown-unicast storm control on the interface, use the no storm- control unknown-unicast [percentage decimal_value in] [wred- profile name]] [packets_per_second in] command.

Parameters

percentage decimal_value [in out]

wred-profile name

E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the network. Optionally, you can designate a decimal value percentage, for example, 55.5%.

The percentage is from 0 to 100:

•0% blocks all related traffic.

•100% allows all traffic into the interface.

The decimal range is from 0.1 to 0.9.

E-Series Only: (Optionally) Enter the keywords wred- profile followed by the profile name to designate a wred- profile.

	packets_per_se	C-Series and S-Series Only: Enter the packets per second of
	cond in	broadcast traffic allowed into the network. The range is from
		0 to 33554431.
Defaults	none
Command	INTERFACE (conf-if-interface-slot/port)
Modes

Storm Control 1549