group, member X accepts the SA message and forwards it to all of its peers that are not part of the mesh-group. However, member X cannot forward the SA message to other members of the mesh-group.

ip msdp originator-id

Configure the MSDP Originator ID.

S6000

Syntax

ip msdp originator-id {interface}

 

To remove the originator-id, use the no ip msdp originator-id

 

{interface} command.

Parameters

Enter the following keywords and slot/port or number

interface

 

information:

Defaults

Command Modes

Command History

•For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

•For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

•For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

•For a port channel interface, enter the keywords port- channel then a number. The range is from 1 to 128.

•For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

Multicast Source Discovery Protocol (MSDP)

985

Page 985
Image 985
Dell 9.7(0.0) manual Ip msdp originator-id interface