Dell 9.7(0.0) manual Radius-server timeout, Radius-server retransmit retries, Retries

radius-server retransmit

Configure the number of times the switch attempts to connect with the configured RADIUS host server before declaring the RADIUS host server unreachable.

Syntax radius-server retransmit retries

Parameters

Defaults

Command Modes

Command History

Related Commands

To configure zero retransmit attempts, use the no radius-server retransmit command.

To return to the default setting, use the radius-server retransmit 3 command.

retries	Enter a number of attempts that FTOS tries to locate a
	RADIUS server. The range is from zero (0) to 100. The default
	is 3 retries.
3 retries
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.2.1.0 Introduced on the E-Series.

radius-server host — configures a RADIUS host.

radius-server timeout

To reply to a request, configure the amount of time the RADIUS client (the switch) waits for a RADIUS host server .

Syntax	radius-server timeout seconds
	To return to the default value, use the no radius-server timeout command.

Security 1399