suppress

max-suppress- time

route-map map-name

again advertised (or no longer suppressed). The range is from 1 to 20000. The default is 750.

(OPTIONAL) Enter a number as the suppress value, which is compared to the flapping route’s Penalty value. If the Penalty value is greater than the suppress value, the flapping route is no longer advertised (that is, it is suppressed). The range is from 1 to 20000. The default is 2000.

(OPTIONAL) Enter the maximum number of minutes a route can be suppressed. The default is four times the half-life value. The range is from 1 to 255. The default is 60 minutes.

(OPTIONAL) Enter the keyword route-mapthen the name of a configured route map.

Only match commands in the configured route map are supported.

Defaults

Command Modes

Command History

Usage Information

Disabled.

•ROUTER BGP

•ROUTER BGP-address-family

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

If you enter the bgp dampening command, the default values for half-life, reuse, suppress, and max-suppress-timeare applied. The parameters are position-dependent; therefore, if you configure one parameter, configure the parameters in the order they appear in the CLI.

Route refresh is sent when you enable BGP dampening.

Border Gateway Protocol

351

Page 351
Image 351
Dell 9.7(0.0) manual Suppress Max-suppress- time, Route-map map-name