Dell 9.7(0.0) manual Disable, Spanning Tree

description

Enter a description of the spanning tree.

Syntax description {description}

Parameters

Defaults

Command Modes

Command History

Related Commands

To remove the description from the spanning tree, use the no description {description} command.

description	Enter a description to identify the spanning tree (80
	characters maximum).

none

SPANNING TREE (The prompt is “config-stp”.)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced

protocol spanning-tree — enters SPANNING TREE mode on the switch.

disable

Disable the spanning tree protocol globally on the switch.

Syntax	disable
	To enable Spanning Tree Protocol, use the no disable command.
Defaults	Enabled (that is, the spanning tree protocol is disabled.)
Command	SPANNING TREE
Modes

1554 Spanning Tree Protocol (STP)