Dell 9.7(0.0) Dcbx detail command, Dcbx version auto cee cin ieee-v2.5, Ieee-v2.5 command

Parameters

config-source auto- downstream auto-upstream manual

Enter the DCBX port role, where:

•config-source: configures the port to serve as the configuration source on the switch.

•auto-upstream: configures the port to receive a peer configuration. The configuration source is elected from auto-upstream ports.

•auto-downstream: configures the port to accept the internally propagated DCB configuration from a configuration source.

•manual: configures the port to operate only on administer-configured DCB parameters. The port does not accept a DCB configuration received form a peer or a local configuration source.

Defaults

Command Modes

Command History

Usage Information

Manual

INTERFACE PROTOCOL LLDP

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX configuration on a port, use the show interface

dcbx detail command.

dcbx version

Configure the DCBX version used on the interface.

Syntax	dcbx version {auto cee cin ieee-v2.5}
	To remove the DCBX version, use the dcbx version {auto cee cin
	ieee-v2.5} command.

Data Center Bridging (DCB) 493