Dell 9.7(0.0) manual PFC Commands, Clear pfc counters, Port-type, All stack-ports, Statistics

Usage Information

Related Commands

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.

By default, iSCSI is enabled on the unit and the flow control is enabled on all of the interfaces. It is also acts as defaults when the link-level flow control is enabled on one or more interfaces.

Enables priority flow control or enhance transmission selection on interface.

dcb <ets pfc> enable — enable priority flow control or enhanced transmission selection on interface.

PFC Commands

The following PFC commands are supported on the Dell Networking OS.

clear pfc counters

Clear the PFC TLV counters and PFC statistics on an interface or stack unit.

Syntax

Parameters

Defaults

Command Modes

Command History

clear pfc counters [port-type slot/port[] stack-unit {unit number all } all stack-ports all}]

port-type	Enter the keywords port-typethen the slot/port
	information.
stack-unit unit	Enter the keywords stack-unitthen the stack-unit number
number	to be cleared.
all stack-ports	Enter the keywords all stack-ports all to clear the
all	counters on all interfaces.
statistics	Enter the keyboard statistics to clear the hardware PFC
	counters.
none
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Data Center Bridging (DCB) 479