VersionDescription

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.1.1.0Introduced on the E-Series.

rmon collection history

Enable the RMON MIB history group of statistics collection on an interface.

S6000

Syntaxrmon collection history {controlEntry integer} [owner name] [buckets number] [interval seconds]

Parameters

Defaults

Command Modes

Command History

To remove a specified RMON history group of statistics collection, use the no rmon collection history {controlEntry integer} command.

controlEntry

Enter the keyword controlEntry to specify the RMON

integer

group of statistics using a value. Then enter an integer value

 

from 1 to 65535 that identifies the RMON group of statistics.

 

The integer value must be a unique index in the RMON

 

history table.

owner name

(OPTIONAL) Enter the keyword owner then the owner name

 

to record the owner of the RMON group of statistics.

buckets

(OPTIONAL) Enter the keyword buckets then the number of

number

buckets for the RMON collection history group of statistics.

 

The bucket range is from 1 to 1000. The default is 50.

interval

(OPTIONAL) Enter the keyword interval then the number

seconds

of seconds in each polling cycle. The range is from 5 to 3600

 

seconds. The default is 1800 seconds.

none

CONFIGURATION INTERFACE (config-if)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

Remote Monitoring (RMON)

1331

Page 1331
Image 1331
Dell 9.7(0.0) manual Rmon collection history, ControlEntry, Owner name, Buckets