Dell 9.7(0.0) manual Dcbx port-role, Reco pfc

Parameters

Defaults

Command Modes

Command History

{ets-conf ets- Enter the PFC and ETS TLVs advertised, where:

reco pfc}

• ets-conf:enables the advertisement of ETS configuration TLVs.

• ets-reco:enables the advertisement of ETS recommend TLVs.

• pfc: enables the advertisement of PFC TLVs.

All PFC and ETS TLVs are advertised.

PROTOCOL LLDP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.

You can configure the transmission of more than one TLV type at a time; for example: advertise dcbx-tlvets-confets-reco.

You can enable ETS recommend TLVs (ets-reco) only if you enable ETS configuration TLVs (ets-conf). To disable TLV transmission, use the no form of the command; for example, no advertise dcbx-tlv pfc ets-reco.

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX configuration on a port, use the show interface dcbx detail command.

dcbx port-role

Configure the DCBX port role the interface uses to exchange DCB information.

Syntaxdcbx port-role {config-source auto-downstream auto-upstream manual}

To remove DCBX port role, use the no dcbx port-role {config-source auto-downstream auto-upstream manual} command.

492 Data Center Bridging (DCB)