The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.8.0Support from 2 to 64 paths on the S4810. Command syntax changed to max-path(was maximum-paths).

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

Usage

If you enable this command, use the clear ip bgp * command to recompute

Information

the best path.

neighbor activate

This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI (Address Family Identifier/Subsequent Address Family Identifier).

S6000

Syntaxneighbor [ip-address peer-group-name] activate

Parameters

Defaults

Command Modes

Command History

To disable, use the no neighbor [ip-address peer-group-name] activate command.

ip-address

(OPTIONAL) Enter the IP address of the neighbor in dotted

 

decimal format.

peer-group-

(OPTIONAL) Enter the name of the peer group.

name

 

activate

Enter the keyword activate to enable the neighbor/peer

 

group in the new AFI/SAFI.

Disabled

CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Border Gateway Protocol

379

Page 379
Image 379
Dell 9.7(0.0) manual Neighbor activate, Activate