Dell 9.7(0.0) manual ETS Commands, Clear ets counters port-type slot/port

ETS Commands

The following ETS commands are supported on the Dell Networking OS.

dcb-enable

Enable data center bridging.

Syntax	dcb enable[pfc-queues 14]
	To disable DCB, use the no dcb enable command.
Parameters	pfc-queues	Enter the pfc-queue range. To disable DCB, use the no dcb

enable command. The range is from 1 or 2.

Defaults

Command Modes

Command History

Usage Information

Related Commands

None

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

Version

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.

By default, iSCSI is enabled on the unit and the flow control is enabled on all of the interfaces. It is also acts as defaults when the link-level flow control is enabled on one or more interfaces.

Enables priority flow control or enhance transmission selection on interface.

dcb <ets pfc> enable — enable priority flow control or enhanced transmission selection on interface.

clear ets counters

Clear all ETS TLV counters on an interface.

Syntax clear ets counters port-type slot/port[]

486 Data Center Bridging (DCB)