Dell 9.7(0.0) manual Show isis database, Example Address- FamilyIPv6, Lspid

Example (Address- Family_IPv6)

spf-interval level-2 120 20 25 exit-address-family

The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.

Dell(conf-router_isis-af_ipv6)#show conf

!

address-family ipv6 unicast maximum-paths 16 multi-topology transition set-overload-bit spf-interval level-1 100 15 20 spf-interval level-2 120 20 25 exit-address-family

show isis database

Display the IS-IS link state database.

S6000

Syntax

Parameters

Command Modes

show isis [vrf vrf-name] database [level-1 level-2] [local] [detail summary] [lspid]

vrf vrf-name	(Optional) Enter the keyword vrf followed by the name of the
	VRF to display IS-IS link state database corresponding to that
	VRF.
	NOTE: If you do not specify this option, the IS-IS link
	state database corresponding to the default VRF are
	displayed.
level-1	(OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2	(OPTIONAL) Displays the Level 2 IS-IS link-state database.
local	(OPTIONAL) Displays local link-state database information.
detail	(OPTIONAL) Detailed link-state database information of each
	LSP displays when specified. If not specified, a summary
	displays.
summary	(OPTIONAL) Summary of link-state database information
	displays when specified.
lspid	(OPTIONAL) Display only the specified LSP.

•EXEC

•EXEC Privilege

896 Intermediate System to Intermediate System (IS-IS)