Dell 9.7(0.0) manual Storm-control broadcast Interface, Storm-control multicast Configuration

storm-control broadcast (Interface)

Configure the percentage of broadcast traffic allowed on an interface (ingress only).

Syntaxstorm-control broadcast [packets_per_second in]

Parameters

Defaults

Command Modes

Command History

To disable broadcast storm control on the interface, use the no storm-control broadcast [packets_per_second in] command.

packets_per_se	Enter the packets per second of broadcast traffic allowed
cond in	into the network. The range is from 0 to 33554368.

none

INTERFACE (conf-if-interface-slot/port)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

7.4.1.0E-Series Only: Added the percentage decimal value option.

6.5.1.0Introduced on the E-Series.

storm-control multicast (Configuration)

Configure the packets per second (pps) of multicast traffic allowed into the C-Series and S-Series networks only.

Syntax	storm-control multicast packets_per_second in
	To disable storm-control for multicast traffic into the network, use the no storm-
	control multicast packets_per_second in command.

1546 Storm Control