The following details the possible speed and auto-negotiation combinations for a line between two 10/100/1000 Base-T Ethernet interfaces.

Port 0

•auto-negotiation enabled* speed 1000 or auto

•auto-negotiation enabled speed 100

•auto-negotiation disabled speed 100

•auto-negotiation disabled speed 100

•auto-negotiation enabled* speed 1000 or auto

Port 1

•auto-negotiation enabled* speed 1000 or auto

•auto-negotiation enabled speed 100

•auto-negotiation disabled speed 100

•auto-negotiation enabled speed 100

•auto-negotiation disabled speed 100

Link Status Between Port 1 and Port 2

•Up at 1000 Mb/s

•Up at 100 Mb/s

•Up at 100 Mb/s

•Down

•Down

* You cannot disable auto-negotiation when the speed is set to 1000 or auto.

portmode hybrid

To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this way is identified as a hybrid port in report displays.

S6000

Syntax

portmode hybrid

 

To return a port to accept either tagged or untagged frames (non-hybrid), use the

 

no portmode hybrid command.

Defaults

non-hybrid

Command

INTERFACE (conf-if-interface-slot/port)

Modes

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

 

The following is a list of the Dell Networking OS version history for this command.

Interfaces

695

Page 695
Image 695
Dell 9.7(0.0) manual Portmode hybrid, No portmode hybrid command