Defaults

Command Modes

Command History

Usage Information

Related Commands

linkdown

linkup

Not enabled.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.2(0.0)

Introduced on the M I/O Aggregator. This command is

 

supported in Programmable-Mux (PMUX) mode only.

9.0.2.0Introduced on the S6000.

9.1(0.0)

Added support for copy-config and ecmp traps.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.4.1.0Added support for VRRP traps.

7.6.1.0Added support for STP and xSTP traps. Introduced on the S- Series.

7.5.1.0Introduced on the C-Series.

E-Series legacy command

Dell Networking OS supports up to 16 SNMP trap receivers.

If you do not configure this command, no traps controlled by this command are sent. If you do not specify a notification-typeand notification-option, all traps are enabled.

snmp-server community — enables SNMP and sets the community string.

snmp-server engineID

Configure the name for both the local and remote SNMP engines on the router.

Syntaxsnmp-server engineID [local engineID] [remote ip-addressvrf

vrf-name udp-portport-number engineID]

1484

Simple Network Management Protocol (SNMP) and Syslog

Page 1484
Image 1484
Dell 9.7(0.0) manual Snmp-server engineID, Linkdown Linkup