Example (Vlan)

Dell(conf-if-vl-20)#interface vlan 10

 

Dell(conf-if-vl-10)#no untagged tengigabitethernet 7/1

 

Dell(conf-if-vl-10)#interface vlan 20

 

Dell(conf-if-vl-20)#no tagged tengigabitethernet 7/1

 

Dell(conf-if-vl-20)#interface tengigabitethernet 7/1

 

Dell(conf-if-gi-7/0)#no portmode hybrid

 

Dell(conf-if-vl-20)#

Related

Commands

rate-interval

show interfaces switchport — displays the configuration of switchport (Layer 2) interfaces on the switch.

switchport — places the interface in a Layer 2 mode.

vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN network.

Configure the traffic sampling interval on the selected interface.

S6000

Syntax

rate-interval seconds

Parameters

seconds

Enter the number of seconds for which to collect traffic data.

 

The range is from 5 to 299 seconds.

NOTE: Because polling occurs every 15 seconds, the number of seconds designated here rounds to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59 seconds rounds to 45.

Defaults

Command Modes

Command History

299 seconds

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

Version 9.0.2.0 Introduced on the S6000.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Interfaces

697

Page 697
Image 697
Dell 9.7(0.0) manual Example Vlan, Rate-interval seconds