Dell 9.7(0.0) manual Show tcp statistics all cp rp1 rp2

quench

0 parameter, 0 timestamp, 0 info request, 0 other Sent: 0 redirects, 0 unreachable, 0 echo, 0 echo reply

0 mask requests, 0 mask replies, 0 quench, 0 timestamp 0 info reply, 0 time exceeded, 0 parameter problem

UDP statistics:

Rcvd: 0 total, 0 checksum errors, 0 no port

0 short packets, 0 bad length, 0 no port broadcasts, 0 socket full

Sent: 0 total, 0 forwarded broadcasts TCP statistics:

Rcvd: 23829 total, 0 checksum errors, 0 no port

Sent: 16048 total ARP statistics:

Rcvd: 156 requests, 11 replies

Sent: 21 requests, 10 replies (0 proxy) Routing Processor1 IP Traffic:

show tcp statistics

View information on TCP traffic through the switch.

S6000

Syntax

Parameters

Command Modes

Command History

show tcp statistics {all cp rp1 rp2}

all	Enter the keyword all to view all TCP information.
cp	Enter the keyword cp to view only TCP information from the
	Control Processor.
rp1	Enter the keyword rp1 to view only TCP statistics from
	Route Processor 1.
rp2	Enter the keyword rp2 to view only TCP statistics from
	Route Processor 2.
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

IPv4 Routing 815