Dell 9.7(0.0) manual Example Bulk, Multiple Ports, Overlapping, Example Single, Range

	• If overlapping port ranges are specified, the port range is extended to the
	smallest start port and the biggest end port.
Example (Bulk)	Dell(conf)#interface range tengigbitethernet 2/1 - 11,
	fortyGigbE 3/3, tengigbitethernet 3/10
	% Warning: Non-existing ports (not configured) are ignored by
	interface-range
Example	Dell(conf)#interface range tengigabitethernet 2/10 - 23,
(Multiple Ports)	tengigabitethernet 2/12 - 17
	Dell(conf-if-range-te-2/10-23)#
Example	Dell(conf)#interface range tengigabitethernet 2/3 - 11,
(Overlapping	tengigabitethernet 2/3 - 23
Ports)	Dell(conf-if-range-te-2/3-23)#
Usage	Only VLAN and port-channel interfaces created using the interface vlan and
Information
	interface port-channel commands can be used in the interface range
	command.
	Use the show running-configcommand to display the VLAN and port-channel
	interfaces. VLAN or port-channel interfaces that are not displayed in the show
	running-configcommand cannot be used with the bulk configuration feature of
	the interface range command. You cannot create virtual interfaces (VLAN,
	Port-channel) using the interface range command.
	NOTE: If a range has VLAN, physical and port-channel interfaces, only
	commands related to physical interfaces can be bulk configured. To configure
	commands specific to VLAN and port-channel only those respective interfaces
	should be configured in a particular range.
Example (Single	This example shows a single range bulk configuration.
Range)	Dell(config)# interface range tengigabitethernet 5/3 - 23
	Dell(config-if-range-te-5/3-23)# no shutdown
	Dell(config-if-range-te-5/3-23#
Example	This example shows how to use commas to add different interface types to the
(Multiple	range enabling all Tengigabit Ethernet interfaces in the range 5/1 to 5/23 and both
Range)	Tengigabit Ethernet interfaces 1/1 and 1/2.
	Dell(config-if)# interface range tengigabitethernet 5/1 -
	5/23, tengigabitethernet 1/1 - 1/2
	Dell(config-if-range-te-1/1-2,te-5/1-23)# no shutdown
	Dell(config-if-range-te-1/1-2,te-5/1-23)#
Example	This example shows how to use commas to add VLAN and port-channel interfaces
(Multiple	to the range.
Range)	Dell(config-if)# interface range tengigabitethernet 5/1 - 23,
	tengigabitethernet 1/1 – 2,
	Vlan 2–100, Port 1–25
	Dell(config-if-range-te-1/1-2,te-5/1-23,vl-2-100,po-1-25)# no

682 Interfaces