Dell 9.7(0.0) manual Qos dscp-color-map, Dellconf-dscp-color-map# dscp yellow 9,10,11,13,15,16

• A DSCP value cannot be in both the yellow and red lists. Setting the red or yellow list with any DSCP value that is already in the other list results in an error and no update to that list is made.

	• Each color map can only have one list of DSCP values for each color; any DSCP
	values previously listed for that color that are not in the new DSCP list are
	colored green.
Example	Dell(conf-dscp-color-map)# dscp yellow 9,10,11,13,15,16
Related	qos dscp-color-map — configures the DSCP color map
Commands
	qos dscp-color-policy— configures a DSCP color policy

qos dscp-color-map

Configure the DSCP color map.

Syntax

Parameters

Defaults

Command Modes

Command History

Usage Information

Example

qos dscp-color-map map-name

To remove a color map, use the no qos dscp-color-mapmap-namecommand.

map-name	Enter the name of the DSCP color map. The map name can
	have a maximum of 32 characters.
None
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.5.0.0Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

A color map outlines the codepoint mappings to the appropriate color mapping (green, yellow, red) for the traffic. The system uses this information use to handle the traffic on the interface based on the traffic priority and places it into the appropriate shaping queue. You cannot delete a DSCP color map when it is configured on an interface. If you do, all the DSCP values are set to green (low drop precedence). To delete the DSCP color map that is being used by one or more interfaces, remove the DSCP map from each interface.

Dell(conf)#qos dscp-color-map mymap

Quality of Service (QoS) 1297