Dell 9.7(0.0) manual Line aux 0 console 0 vty number end-number, End-number

line

Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the access conditions for the designated line.

Syntax

Parameters

Defaults

Command Modes

Command History

line {aux 0 console 0 vty number [end-number]}

aux 0	Enter the keyword aux 0 to configure the auxiliary terminal
	connection.
console 0	Enter the keyword console 0 to configure the console
	port. The console option for the S-Series is <0-0>.
vty number	Enter the keyword vty then a number from 0 to 9 to
	configure a virtual terminal line for remote sessions. The
	system supports 10 remote sessions.
end-number	(OPTIONAL) Enter a number from 1 to 9 as the last virtual
	terminal line to configure. You can configure multiple lines at
	one time.
Not configured
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.0.2.0	Introduced on the S6000.
8.3.19.0	Introduced on the S4820T.
8.3.12.0	Introduced on the S4810.
8.3.11.1	Introduced on the Z9000.
8.1.1.0	Introduced on the E-Series ExaScale.
7.6.1.0	Introduced on the S-Series.
7.5.1.0	Introduced on the C-Series.
E-Series	Original command

Usage	You cannot delete a terminal connection.
Information
Related	access-class — restricts the incoming connections to a particular IP address in an
Commands	IP access control list (ACL).

116 Control and Monitoring