To enter INTERFACE mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the interface command and then enter an interface type and interface number that is available on the switch.

The prompt changes to include the designated interface and slot/port number. For example:

Prompt

Interface Type

Dell(conf-if)# INTERFACE mode

Dell(conf-if-Gigabit Ethernet interface then the slot/port information gi-0/0)#

Dell(conf-if-Ten-Gigabit Ethernet interface then slot/port information te-0/0)#

Dell(conf-if-Forty-Gigabit Ethernet interface then slot/port information fo-0/0)#

Dell(conf-if-Loopback interface number lo-0)#

Dell(conf-if-Null Interface then zero nu-0)#

Dell(conf-if-Port-channel interface number po-0)#

Dell(conf-if-VLAN Interface then VLAN number (range 1–4094) vl-0)#

Dell(conf-if-Management Ethernet interface then slot/port information ma-0/0)#

Dell(conf-if-Tunnel interface then tunnel ID. tu-0)#

Dell(conf-if-Designated interface range (used for bulk configuration). range)#

IP ACCESS LIST Mode

To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-list standard or ip access-list extended command.

To enter IP ACCESS LIST mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Use the ip access-list standard or ip access-list extended command. Include a name for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).

You can return to CONFIGURATION mode by using the exit command.

ISIS ADDRESS-FAMILY Mode

To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to Intermediate System to Intermediate System (IS-IS).

52

CLI Basics

Page 52
Image 52
Dell 9.7(0.0) manual IP Access List Mode, Isis ADDRESS-FAMILY Mode, Prompt, Dellconf-if# Interface mode