Dell 9.7(0.0) manual Show ip bgp, Ipv4 unicast, Network-mask

Command Modes

Command History

Example

ROUTER BGP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

Dell(conf-router_bgp)#show config

!

router bgp 100 network 1.1.11.1/32 network 1.1.12.1/32 network 1.1.13.1/32

neighbor 10.1.1.2 remote-as 200 neighbor 10.1.1.2 no shutdown

show ip bgp

View the current BGP IPv4 routing table for the system.

S6000

Syntaxshow ip bgp [vrf vrf-name] [ipv4 unicast] [network [network-

mask] [longer-prefixes]]

Parameters	(OPTIONAL) Enter the keyword vrf and then the name of
vrf vrf-name
	the VRF to view ipv4–unicast route information
	corresponding to that VRF.
ipv4 unicast	(OPTIONAL) Enter the keywords ipv4 unicast to view
	information only related to ipv4 unicast routes.
network	(OPTIONAL) Enter the network address (in dotted decimal
	format) of the BGP network to view information only on that
	network.
network-mask	(OPTIONAL) Enter the network mask (in slash prefix format)
	of the BGP network address.

416 Border Gateway Protocol