Dell 9.7(0.0) manual Router bgp as-number, Error No router id configured

router bgp

To configure and enable BGP, enter ROUTER BGP mode.

S6000

Syntax	router bgp as-number
	To disable BGP, use the no router bgp as-numbercommand.
Parameters	as-number	Enter the AS number. The range is from 1 to 65535 (2 byte),

from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted format).

Defaults

Command Modes

Command History

Usage Information

Example

Not enabled.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:

%Error: No router id configured

BGP does not allow 23456 (AS-TRANS) as a configured AS number.

Dell(conf)#router bgp 3

Dell(conf-router_bgp)#

Border Gateway Protocol 413