Dell 9.7(0.0) manual Sflow sample-rate Interface

sflow sample-rate (Interface)

Change the interface default sampling rate.

Syntax	sflow sample-rate value
	To return to the default sampling rate, use the no sflow sample-rate
	command.
Parameters	value	Enter the sampling rate value. For the C-Series and S-Series,
		the range is from 256 to 8388608 packets. Enter values in
		powers of 2 only; for example, 4096, 8192, 16384, etc. The
		default is 32768 packets.
Defaults	The Global default sampling.
Command	CONFIGURATION
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on S-Series Stacking.

8.1.1.0Introduced on the E-Series ExaScale.

7.7.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

Usage	This command changes the sampling rate for an interface. By default, the sampling
Information	rate of an interface is set to the same value as the current global default sampling
	rate. If the value entered is not a correct power of 2, the command generates an
	error message with the previous and next power-of-2 value. Select one of these
	two number and re-enter the command.
Related	sflow sample-rate (Global) — changes the sampling rate globally.
Commands

1472 sFlow