Dell 9.7(0.0) manual Reload, Nvram-cfg, Change

Example (IPv6)

reload

Reply to request 5 from 172.31.1.66 0 ms

Reply to request 5 from 172.31.1.87 0 ms

Dell#

Dell#ping 100::1

Type Ctrl-C to abort.

Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds:

!!!!!

Success rate is 100.0 percent (5/5), round-trip min/avg/max = 0/0/0 (ms)

Dell#

Reboot Dell Networking Operating System (OS).

Syntax

Parameters

reload [conditional nvram-cfg-change]

conditional	Reload if the condition is true. A configuration change to the
nvram-cfg-	nvram requires a switch reload. To reload the switch, select
change	nvram-cfg-change.

Command Modes

Command History

EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.0.0.0Introduced on the Z9000.

9.1(0.0) Added ‘conditional’ parameter.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

E-Series Original command.

Usage	If there is a change in the configuration, FTOS prompts you to save the new
Information	configuration. Or you can save your running configuration with the copy
	running-configcommand. Use the conditional parameter if any configuration

Control and Monitoring 121