To enter ISIS ADDRESS-FAMILY mode:

1.Verify that you are logged in to ROUTER ISIS mode.

2.Enter the command address-family ipv6 unicast. The prompt changes to include (conf- router_isis-af_ipv6).

LLDP Mode

To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, refer to Link Layer Discovery Protocol (LLDP).

To enter LLDP mode:

1.To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an interface, verify that you are logged in to INTERFACE mode.

2.Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if- interface-lldp).

LLDP MANAGEMENT INTERFACE Mode

To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP MANAGEMENT INTERFACE mode.

To enter LLDP MANAGEMENT INTERFACE mode:

1.Verify that you are logged in to LLDP mode.

2.Enter the management-interfacecommand. The prompt changes to include (conf-lldp-mgmtIf).

LINE Mode

To configure the console or virtual terminal parameters, use LINE mode.

To enter LINE mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the line command. Include the keywords console or vty and their line number available on the switch. The prompt changes to include (config-line-console) or (config-line-vty).

You can exit this mode by using the exit command.

MAC ACCESS LIST Mode

To enter MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the mac access-list standard or mac access-list extended command.

To enter MAC ACCESS LIST mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Use the mac access-list standard or mac access-list extended command. Include a name for the ACL. The prompt changes to include (conf-std-macl) or (conf-ext-macl).

You can return to CONFIGURATION mode by using the exit command.

MONITOR SESSION Mode

To enable and configure a traffic monitoring session using port monitoring, use MONITOR SESSION mode. For more information, refer to Port Monitoring.

CLI Basics

53

Page 53
Image 53
Dell 9.7(0.0) manual Lldp Mode, Lldp Management Interface Mode, Line Mode, MAC Access List Mode, Monitor Session Mode