Usage

To avoid denial of service (DOS) attacks, keep the number of fragments allowed for

Information

re-assembly low.

ip name-server

Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order of their use.

S6000

Syntaxip name-serveripv4-address [ipv4-address2...ipv4-address6]

To remove a name server, use the no ip name-serverip-addresscommand.

Parameters

Enter the IPv4 address, in dotted decimal format, of the

ipv4-address

 

name server to be used.

ipv4-address2...

(OPTIONAL) Enter up five more IPv4 addresses, in dotted

ipv4-address6

decimal format, of name servers to be used. Separate the

 

addresses with a space.

Defaults

Command Modes

Command History

Usage Information

No name servers are configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0

Introduced on the E-Series.

Dell Networking OS does not support sending DNS queries over a VLAN. DNS queries are sent out on all other interfaces, including the Management port.

772

IPv4 Routing

Page 772
Image 772
Dell 9.7(0.0) manual Ip name-server, Ipv4-address2, Ipv4-address6