Dell 9.7(0.0) manual Service-pool wred

rate-shape kbps command, it denotes the metric for peak and committed rate attributes). Similarly, if you use the rate-shape pps option , it denotes the metric for peak rate and committed rate attributes.

If you attempt to define the committed rate to be less than the peak rate, an error message is displayed stating that the peak rate cannot be lower than the committed rate. You can configure all the rate shaping parameters to be either in bytes or packets measure for each queue. The rate and burst parameters for both minimum and maximum settings for a queue can be either in packets or bytes. You cannot configure some of rate shaping attributes to be in bytes measure and the remaining rate shaping attributes to be in packets measure; all the rate shaping attributes must contain the same metric or unit of measure.

Example	Dell (conf-qos-policy-out) #rate-shape	pps 100 100 peak pps
	1000 200
	Dell (conf-qos-policy-out) #rate-shape	kbps	1024	100	peak kbps
	102400 75
	Dell (conf-qos-policy-out) # rate-shape 100		100 peak		1000 750
	Dell(conf-qos-policy-in)#rate-police 100 25		peak	80 500
	% Error: Peak rate cannot be less than	committed		rate.

service-pool wred

A global buffer pool that is a shared buffer pool accessed by multiple queues when the minimum guaranteed buffers for the queue are consumed can be configured on the S6000 and Z9000 platforms.

Create a global buffer pool that is a shared buffer pool accessed by multiple queues when the minimum guaranteed buffers for the queue are consumed. S4810, S4820T, S6000, and Z9000 platforms support four global service-pools in the egress direction. Two service pools are used—one for lossy queues and the other for lossless (priority-based flow control (PFC)) queues. You can enable WRED and ECN configuration on the global service-pools. You can define WRED profiles and weight on each of the global service-pools for both lossy and lossless (PFC) service-pools.

Syntax

Parameters

[No] service-pool wred {green weight yellow} {[pool0

number/string] [pool1 number/string]}

service-pool	Define the mapping between the service class and policy-
	based QoS or routing.
wred	Specify WRED curve parameters for a queue.
green	Specify green (low) drop precedence to a queue.
weight	Specify a weight factor to a queue.
yellow	Specify yellow (medium) drop precedence to a queue.
pool0	Service-pool buffer 1 (default service-pool for PFC traffic) .
pool1	Service-pool buffer 0 (default service-pool for lossy traffic).
number	Enter a weight for the queue as a number in the range of 1 to
	15. This parameter applies only if you specify the green or
	yellow drop precedence.

1294 Quality of Service (QoS)