Dell 9.7(0.0) manual Untagged interface

Related Commands

If the track ip command is not configured, the VLAN's Layer 3 operational state depends on all the members of the VLAN.

The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the track ip command configuration.

interface vlan — configures a VLAN.

tagged — specifies which interfaces in a VLAN are tagged.

untagged

Add a Layer 2 interface to a VLAN as an untagged interface.

S6000

Syntax untagged interface

Parameters

Defaults

Command Modes

Command History

To remove an untagged interface from a VLAN, use the no untagged interface command.

interface	Enter the following keywords and slot/port or number
	information:
	• For a port channel interface, enter the keywords port-
	channel then a number. The range is from 1 to 128.
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.

All interfaces in Layer 2 mode are untagged.

INTERFACE VLAN

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

942 Layer 2