Usage Information

Related Commands

VersionDescription

9.7(0.0)

Added the dmzlink-bw parameter.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

You can assign up to 256 peers to one peer group.

When you add a peer to a peer group, it inherits all the peer group’s configured parameters. A peer cannot become part of a peer group if any of the following commands are configured on the peer:

•neighbor advertisement-interval

•neighbor distribute-list

•neighbor route-map

•neighbor route-reflector-client

if a neighbor’s configuration is more specific than its peer group’s configuration, the neighbor may retain its configuration after it is added to the peer group. The neighbor’s configuration does not affect outgoing updates.

A peer group must exist (be enabled) before you add a peer to it. If the peer group is disabled (shutdown), the peers within that group are also disabled (shutdown).

In BGP, you cannot associate a peer to a peer-group without configuring the remote-as for Internal BGP (IBGP) or External BGP (EBGP).

This command automatically restarts the neighbor session for the configuration to take effect.

clear ip bgp — resets BGP sessions.

neighbor peer-group (creating group) — creates a peer group.

show ip bgp peer-group — views BGP peers.

show ip bgp neighbors — views BGP neighbors configurations.

394

Border Gateway Protocol

Page 394
Image 394
Dell 9.7(0.0) manual Added the dmzlink-bw parameter